Yep. A faux pas. It has come time for omscaler to “fess up”. What has happened is that a flaw has been discovered. The problem is that none of the turnouts have been recessed when they were installed. All fourteen of ‘em. Everyone. Omscaler thought a little funny that equipment going through the turnouts seemed to move somewhat roughly. “Odd,” I thought to myself. Some days after it dawned on the erstwhile omscaler that the turnouts had not been recessed as they were on the previous module. So, this week’s priority is to correct that error. This work has already been facilitated by a discovery that will be helpful. Before the error was discovered, omscaler began working on figure building. One idea that was tried was quilling. This did not work as hoped but the method can be used to make repair support pillars if they are needed. A silver lining to the turnout resetting cloud. Until next post, omscaler
